Fast & free stop-desk delivery from 4000 DA | Flexible payment | Technical support for your builds

Motor Drivers

37 results

Motor drivers to control a DC motor, a stepper or a brushless motor from an Arduino board, ESP32 or a PLC: H-bridges, stepper modules, PWM controllers and ESCs.

Related categories

37 results

37 results

123

Choosing a motor driver

The choice always starts from the motor, not the control board. A DC motor is driven with an H-bridge: the L298N for small setups, the TB6612FNG when you want fewer losses at low voltage, the DRV8833 for two small motors, and the BTS7960 (5.5-27 V, 43 A max) when the current gets serious. The RZ7889 or the L293D suit miniature motors.

For a stepper motor, you need a current-limiting driver: A4988 (8-35 V) or DRV8825 (8-35 V, 2.2 A max) on a CNC board or a 3D printer, TB6600 or DM556 / DM860H for machines with NEMA 23 motors and above. The small unipolar 28BYJ-48, on the other hand, only needs a ULN2003 module.

  • Voltage: the motor supply voltage must stay within the driver's range, not the Arduino's.
  • Current: compare the motor's current under load to the driver's continuous current, not the peak.
  • Control: PWM + direction (H-bridge), or STEP/DIR (stepper), or servo signal (brushless ESC).
  • Cooling: heatsink and ventilation beyond 1 to 2 A.

Brushless motors for drones or RC models require an ESC, available in several current ratings. On the components side, the ULN2003 and ULN2803 in DIP-16 are used for relays, small solenoids and unipolar motors. The rest of the mechanics can be found in Motors and actuators.

Frequently asked questions

What is the difference between the L298N and the TB6612FNG ?

Both are dual H-bridges for DC motors. The L298N is bipolar and loses about two volts internally, which causes heating; the TB6612FNG (2.7-15 V) is MOSFET-based, more efficient and more compact, but handles less current.

A4988 or DRV8825 for a CNC machine or a 3D printer ?

Both are used the same way in STEP/DIR mode and fit on the same boards. The DRV8825 handles higher current (2.2 A max) and microstepping down to 1/32, the A4988 goes down to 1/16; in both cases you need to set the current-limit potentiometer before powering the motor.

Can a brushless motor be driven with an H-bridge ?

No. A brushless motor has three phases and requires electronic commutation: it needs an ESC, controlled by a servo-type signal from the Arduino or a radio receiver.

How can the speed of a 12 V or 24 V motor be varied without a microcontroller ?

A standalone PWM controller with a potentiometer is enough, such as the 12 VDC modules or the universal versions covering 6 to 90 V. Check that the motor's current under load stays below the controller's rated capacity.

What makes the price of a motor driver vary ?

The allowable current, the output technology (bipolar transistors or MOSFETs), the presence of protections and a heatsink, and the form factor: a DIP-16 integrated circuit is not in the same category as a CNC driver in a metal housing.